JIT Blog

  • Home
    Home This is where you can find all the blog posts throughout the site.
  • Categories
    Categories Displays a list of categories from this blog.
  • Tags
    Tags Displays a list of tags that have been used in the blog.
  • Bloggers
    Bloggers Search for your favorite blogger from this site.
  • Team Blogs
    Team Blogs Find your favorite team blogs here.
Subscribe to this list via RSS Blog posts tagged in clean
Surface Preparation & Application Guidelines

For best results, ensure surfaces are clean, dry and free from oil & grease.

Abrade - to provide a key, abrasion can enhance bond strength by up to 30%.

Clean - using a non-residual surface cleaner.

Prime - using a surface primer chemically alters the surface energy of the substrate to more readily accept adhesive and increases bond strength.

Application - apply bonding tape with the use of a roller, applying firm pressure.  Remove liner, apply second substrate and again apply firm pressure to the bond with the roller.

Bond strength is dependant upon the degree of adhesive to surface contact therefore firm application pressure develops better contact and resulting bond strength is improved.

After application bond strength will increase with 60% strength achieved within 20 minutes, 90% after 24 hours and 100% bond strength achieved after 72 hours.  Ultimate bond strength can be achieved sooner by exposing bond to high temperatures (i.e. +70oC for 1 hour).

b2ap3_thumbnail_If-I-had-a-hammer.png

Application Temperature:   Ideal application range is +19oC to +25oC

Minimum Temperature: +10oC - Try to avoid applying to surfaces below this temperature as adhesive becomes firmer and condensation will form on substrates.  High strength bonding tapes - plastic and crystal can be applied at lower temperatures but condensation must be removed immediately prior to bonding.

Surfaces requiring sealing - most porous surfaces i.e. concrete, wood etc., will require sealing to provide surface integrity. Some materials i.e. copper, brass, galvanised steel and plasticised vinyl may require priming to prevent interaction between adhesive and substrate.  Prime glass for applications in areas of high humidity with surface primer.

 

For technical support & advice for all bonding applications, please contact us on 01698 748290 or email This email address is being protected from spambots. You need JavaScript enabled to view it.